Your Shopping Cart Contents

August 6th, 2008 by Mark M.

Product: Woodworker II

Rating: 5 of 5 stars

Hello--
You guys probably get kudos all of the time. I'm a beginner woodworker with a limited shop and budget. However, I sprung for a woodworker 2 with a standard kerf because you advertised that the edges would be good enough to glue without additional steps.
This is my first project. A few passes through the table saw, and sure enough the pieces for the tabletop were good enough to glue. Crosscuts are very clean. All of my joints are tight. I did experiment with a router pattern bit and a straight edge and in my view your saw blade yielded a superior result.
But you probably knew all of that.
Thanks
Mark Eisenbies

November 13th, 2018 by Lou C.

Product: Leecraft Zero Clearance Inserts

Rating: 5 of 5 stars

Morning Janet:
Thank you for forwarding my interest in the Miter Saw Inserts to Mr. Lee. Appreciated that. I'm hoping he will find the option of making a model that fits my saw and I'll have the opportunity to improve it, as I have done with my table saw.
Was impressed with your knowledge and skill level, from the first time we talked about table saw inserts some time ago.
Took some time to look at the other tools and equipment you carry as well.
Thanks again and continued success in your pursuits.
Lou

April 26th, 2010 by Paul

Product: HT-1 Leecraft Insert

Rating: 5 of 5 stars

I have purchased one already for a thin kerf. Much better than the original mfg's by a long shot. I recommend it to all. I have the 10" Hitachi table saw, but if it is the same for all, then get it, you will appreciate it very much. Paul V.