Zero-Clearance Inserts Zero-Clearance Inserts Laguna #JT-7 Leecraft Zero-Clearance Table Saw Insert 14"L x 4-1/8"W w/RIVING KNIFE SLOT
Here are the Leecraft Zero-Clearance Inserts for your Laguna 10" Fusion 1.75 HP Table Saw
Model JT-7 14"L x 4-1/8"W - Fits Laguna 10" Fusion 1.75 HP WITH riving knife slot
Model JT-8 14"L x 4-1/8"W - Fits Laguna 10" Fusion 1.75 HP WITHOUT riving knife slot for dado or angle cuts
#JT-7 Leecraft Zero-Clearance Table Saw Insert 14"L x 4-1/8"W with RIVING KNIFE SLOT for NEW Jet JPS-10TS ProShop, Jet #708490, #708491, #708492, #708493, #708494, #708495. Also fits the 1.75 HP 10” Laguna Fusion saw, Grizzly: G0661, G0713, G0732 and Baileigh TS-1044H.
The Zero Clearance concept is simple: the blade cuts its own perfectly sized slot by being raised through a machinable "blank" insert. Most inserts are 1/2-inch thick, high-density phenolic laminate, with a bonded-melamine surface. They offer superior rigidity, flatness, durability, and low friction and should not be confused with inferior HD/PP inserts. There's just no comparison! They feature leveling screws, side and end adjustment screws for a vibration-free fit, rear safety pin for lift-out protection, and a pre-cut blade bottom pocket that provides clearance for fully retracted blades and bevel cuts. (Some inserts use OEM screws to hold inserts in place). Instructions also included. Use carbide-tipped blades only. A pre-cut starter pocket makes cutting the clearance slot easy and a finger hole makes for simple removal and hanging. Colors may vary. Made in USA.
Use MicroJig MJ Splitter Kits for added table saw safety. Available in THICK or THIN kerf they are easily installed and simple to align. Not for use with Leecraft inserts that already have the riving knife slot cut in. Intended for inserts WITHOUT the riving knife slot.