Your Shopping Cart Contents

May 15th, 2015 by Tom C.

Product: chop master blade

Rating: 5 of 5 stars

10 Star Rateing:
I placed an order for a Forrest Blade for my miter chop saw from Janet. She was so perfect telling me about the blade. And what would work best for me. This is what makes them stand out from all the other companys. The quality service product and made in the U. S. A. It doesn't get any better then this.
Thank You Janet, Your #1
Sincerely Tom Capps

August 6th, 2008 by Mark M.

Product: Woodworker II

Rating: 5 of 5 stars

Hello--
You guys probably get kudos all of the time. I'm a beginner woodworker with a limited shop and budget. However, I sprung for a woodworker 2 with a standard kerf because you advertised that the edges would be good enough to glue without additional steps.
This is my first project. A few passes through the table saw, and sure enough the pieces for the tabletop were good enough to glue. Crosscuts are very clean. All of my joints are tight. I did experiment with a router pattern bit and a straight edge and in my view your saw blade yielded a superior result.
But you probably knew all of that.
Thanks
Mark Eisenbies

March 9th, 2013 by Bill W.

Product: BH-1

Rating: 4 of 5 stars

Installed this zero clearance insert on my Bosch 4100-09 on 3/9/13. The quality, fit and finish are excellent, as are the installation instructions. I actually spent more time trying to get the insert 'level and stable' in my Bosch table than setting up and cutting the insert. I don't know if my table insert opening is not quite 'level' all the way around but that could be the case as the Leecraft insert is certainly level. I installed a new Freud LU87R010 to go with the new insert.