Looking for rosettes, plinth blocks, moulding or wood stair parts? Check out our sister site, Little Buffalo Moulding and Stair Parts

Customer Reviews

Hello-- You guys probably get kudos all of the time. I'm a beginner woodworker with a limited shop and budget. However, I sprung for a woodworker 2 with a standard kerf because you advertised that the edges would be good enough to glue without additional steps. This is my first project. A few passes through the table saw, and sure enough the pieces for the tabletop were good enough to glue. Crosscuts are very clean. All of my joints are tight. I did experiment with a router pattern bit and a straight edge and in my view your saw blade yielded a superior result. But you probably knew all of that. Thanks Mark Eisenbies
From: Mark M.

Products On Sale

#CM12806115A
12" x 80 tooth .115" kerf 5/8" bore 4PTS + 1 FLAT TS Forrest 12"x80T CHOPMASTER with 5/8" HOLE - $15.00 OFF Sharpening Offer Included
~~WAS $158.75~~ NOW $144.75

See All Sale Items

Saw Blades INDUSTRIAL SAW BLADES Popular Machinery & Tools Melamine Saws Popular Tools 300mm x 80T HATB Melamine Blade, 30mm Hole, 2 +2 Pinholes

A higher angle on the top bevel (+30 degrees) gives this saw an extra sharp shearing action to slice through single or double sided laminates without chipping. These blades are good for laminates, melamine, coreboard and other composite materials. Made with Micro-Sheen C-4 sub-micron Carbide for an extended life.