Your Shopping Cart Contents

December 9th, 2008 by John L.

Product: Woodworker II

Rating: 5 of 5 stars

Hello...since I'm one of the country's "downsized" people right now...I've been working on a custom dresser for my wife. I am just about to begin doing the drawer fronts with miters...and I hadn't yet used the 10" 40T Woodworker II blade I bought at the 2007 Milwaukee woodworking show....WOW!!! I am amazed!!!! I could tell the minute the blade touched the wood there was a difference...MUCH quieter!!! And the resulting cut's surface....JUST LIKE A BABY's BEHIND!!! SMOOOOOTH!! Thanks for having a product that does live up to its hype!!!

November 9th, 2019 by Jody B.

Product: DL-7

Rating: 5 of 5 stars

Outstanding throat plate for my Delta Unisaw. Fix perfectly, better than my factory plate. The only thing I would change about this plate would be using 2 screws on the side adjustment. One on the front side and one on the back side, with such a wide opening (5") you still get very little play.

August 6th, 2008 by Mark M.

Product: Woodworker II

Rating: 5 of 5 stars

Hello--
You guys probably get kudos all of the time. I'm a beginner woodworker with a limited shop and budget. However, I sprung for a woodworker 2 with a standard kerf because you advertised that the edges would be good enough to glue without additional steps.
This is my first project. A few passes through the table saw, and sure enough the pieces for the tabletop were good enough to glue. Crosscuts are very clean. All of my joints are tight. I did experiment with a router pattern bit and a straight edge and in my view your saw blade yielded a superior result.
But you probably knew all of that.
Thanks
Mark Eisenbies